Kamu bisa mendengarkan dan download lagu MP3 Bracelet making process secara gratis di lagu123.biz. Jangan lupa untuk membeli kaset dan CD original serta menjadikan lagu ini sebagai ringtone kamu.
Data lagu:
The process of making an amazing cuff bracelet:
I found some rusty copper wire in my workshop and removed the patina from the wire. I did this with a brass spider figure, which I made a hole in so that I could pull the copper wire through the spider's body and thereby remove the oxidation. A fun process that I will use another time as well. After annealing the copper wire, I took 4 copper rods – 1 of 4 mm and 3 pcs. of 3mm, after which I twisted the copper wire tightly around one of the copper rods of 3 mm (30 cm) and 2 x around the copper rod of 4 cm (30 cm.)
Then I placed in the vice the twisted copper wire with a diameter of 3mm on a copper rod of 3mm in the middle and the 2 other twisted copper wires (of 4 mm in dia.) on their own copper rod of 3mm – on each side of the first twisted copper wire. It is important here that the 2 outermost twisted copper wires are the 4mm ones, because this helps create the final design of the copper bracelet.
I took the last bit of copper wire and twisted it around the 3 copper rods so that they formed a single copper rod. I then bent this twisted copper assembly on my bracelet's bender, which is a former table leg.
After measuring how long the bracelet should be (8 20 cm), I cut the ends off with a jewelry saw. I then used the ends of the small copper rods by hammering them flat, sanding them at the edges so that they were straight and then I could use them as the ends of the bracelet. I did this by folding them around the ends of the b